Go Back   The Mustang Collective Forums > Members List

TexasBlownV8 is just really nice, in an annoying Ryan Seacrest sort of way.TexasBlownV8 is just really nice, in an annoying Ryan Seacrest sort of way.TexasBlownV8 is just really nice, in an annoying Ryan Seacrest sort of way.

TexasBlownV8 Offline

Formerly: TexasBlownV6

Visitor Messages

Showing Visitor Messages 1 to 10 of 15
  1. mustang7
    Hey Mike this is erny, I had a question I was hoping you can help me out with I'm doing and auto to manual swap on my 07 v6 and I had a question about the pressure plate bolts do you know if the pressure plate bolts use locking washer on them or is it just the bolt
  2. Batman
    Hi, I wonder if you can shed any light on the issue I have:- The car drives ok on the way to the track. Burn-out, no problem. Race down the strip and the moment I lift of the gas my engine management light and the wrench light come on. Complete loss of power (Limp mode). Check codes and P2104 appears. Clear fault code and re-start car everything as normal? Changed TB and TPS (1.26 volts) both are brand new. Go and do another run and the same thing happens...!! Re-flash the tune incase it's corrupted and do another run and the same thing happens again. Removed pipework to air filter to watch throttle body. If I press the gas pedal down slowly it works as it should but if I take my foot off the gas pedal quickly as you do at the track the motor on the TB seems to return to the closed position but it seems to twitch open/shut at the end? Is this normal? I would appreciate any help with this issue, regards, Vic.
  3. TexasBlownV8
    I run 10w-30, but it doesn't get 'cold' here.
  4. rampant racing
    rampant racing
    Yea that's what I figured but wanted to hear from another 4.0 owner with experience. Mine is also at low limits so more clearance. May go to a bit thicker oil.
  5. TexasBlownV8
    when hot, it can get low. I've seen it around 30, even lower at times. The thinner oil doesn't help.
  6. rampant racing
    rampant racing
    did you ever have a gauge on your v6 mike as far as oil pressure at idle went? I am getting about 25 psi hot at idle. I have cut the crank to low limits mind you and running 5w/30 oil. thanks.
  7. TexasBlownV8
    how much are you cranking it? it might take quite a bit to build pressure. You know how it is when you change the oil, after starting it takes a few seconds for the oil pressure to come up?

    One thing I do on the V8's is to coat all the parts in oil good, and to prime some oil pressure before starting (using a hand-sprayer pump attached to the oil pressure sensor port using a npt hose-barb fitting, to pump up some pressure and force oil into the engine).

    You should be able to crank it enough so that eventually it builds some pressure.
  8. rampant racing
    rampant racing
    mike not getting oil pressure cranking the motor over with fuel pump and coil off. I have a mechanical gauge. should I see pressure on these motors or will it need started up to get pressure? don't want to eff this up again. the oil lines are correct lol.
  9. Batman
    Hi, I'm looking for the write up on the FPDM wiring upgrade... can you point me in the right direction, cheers, Vic
  10. ex91
    Hey mike I'm running a auto computer with a man car with the proper wireharness. Getting. P061C code. With running the auto computer is there any wires I have to change?

About Me

  • About TexasBlownV8
    Real Name
    Georgetown, TX
    Software guru
    What car do you drive?
    2005 Ford Mustang V6 swapped to V8
    Car Color
    Windveil Blue
    Engine Modifications
    Cams,130mmTB,forged internals,American Racing LTs,electric water pump,billet oil pump gears
    Power Adder
    KB 2.6 Supercharger
    Rear Wheel Horsepower and Torque
  • Signature
    Mike - Three turbos, two Mustangs...do the math.

    "Sally", The Beast: 2005, 5.0L V8 stroker, forged/cammed, twin-turbos; 4r70W full-auto trans, CircleD converter; Shaftmasters driveshaft; GT500 8.8 w/3.73's; VEI digital gauges, PLX widebands; full suspension.

    (Formerly a V6 Automatic with Vortech SQ supercharger & custom a/a intercooler -- 310 RWHP, w/best 1/4: 12.79 @ 107)

    2006 4.0L V6 with PowerHouse Turbo, TR6060.

    It's not just racing...it's an obsession.
    "The brawl inspires many, but few acheive greatness"; "Poop happens" - JujuFox


Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 5 Days Ago
  • Join Date: 02-27-2009
  • Referrals: 2


Showing Friends 1 to 5 of 5

My Vehicles

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
vBulletin Skin developed by: vBStyles.com
Shoutbox provided by vBShout v6.2.1 (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.